Dash Rendar Posted October 28, 2007 Share Posted October 28, 2007 I've just taken ownership of a Supra with a Clifford Concept 300 alarm. Currently, the audible chirps (when arming/disarming) are disabled. I've been trying to enable them, but the system is not behaving as the manual describes. I've gone into Valet mode using my PIN no problem. Then, on p18 of the manual, it says to hold down the * button on the PlainView 2 for 3 seconds until I hear a siren chirp. This doesn't happen when I hold it down. (Could these chirps be disabled too?) Then, when I do the "feature select", I press the unmarked button twice. But instead of the alarm then chirping twice to confirm my selection, it chirps three times, which I think means it's gone back to feature select mode. Similarly, if I then press the * button once (either before or after these three chirps), the alarm then chirps at me three times again. It doesn't appear to be behaving as the manual describes. I was wondering if anyone could shed any light on this for me. Link to comment Share on other sites More sharing options...
jazz1 Posted October 28, 2007 Share Posted October 28, 2007 is that you doing a side kick in your avtar:) Link to comment Share on other sites More sharing options...
Dash Rendar Posted October 28, 2007 Author Share Posted October 28, 2007 Sure is. Link to comment Share on other sites More sharing options...
uk-rich Posted October 28, 2007 Share Posted October 28, 2007 battery low in the fob ?, they do thingslike that to tell you or PM matt harwood Link to comment Share on other sites More sharing options...
Dash Rendar Posted October 28, 2007 Author Share Posted October 28, 2007 I'm not using the fob for any of this, so I don't think that's an issue, but thanks for the suggestion. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now