TrickTT Posted August 16, 2007 Share Posted August 16, 2007 I have a Greddy 60mm electronic peak hold boost gauge and it has developed a problem. It worked fine last time i used the car, but today, the warning light is flashing and it reads low. When the engine is off, it is showing about 400mm/hg vac (instead of 0) and the with the engine on, the needle sits right on the lower stop. I know the pressure signal from the manifold is ok as the avcr uses the same take off and that works fine. I suspect the pressure sensor, but has anyone else had a similar problem? Link to comment Share on other sites More sharing options...
Sandy-m2 Posted August 16, 2007 Share Posted August 16, 2007 check the web site, i have been looking at gauges the last few days and some of them have certian positions they sit in wen they have a problem like a short circit or something. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now