Bob Posted March 3, 2007 Share Posted March 3, 2007 Decided to sell off what was going to be my install, as I really can't be bothered with ICE any more - I much prefer the sound of turbos! All prices + postage and paypal fees 1.) Phoenix Gold Titanium Distribution Blocks (on ebay here) £120 the pair 2.) Phoenix Gold Titanium EQ15 (on ebay here) £100 3.) Phoenix Gold Titanium 600.2 2-channel amplifier This has a tiny bit of rust on the front of the case (thanks to the wife sticking it in the garage wihtout my knowing!) but works fine £250 ono http://www.phoenixgold.com/2004/images/titanium/amplifiers/ti600.2.jpg http://www.phoenixgold.com/2004/titaniumamps.html 4.) Phoenix Gold Xenon 1200.1 1200w single channel amp Brand new, still in the box, never used. Will provide 1200w RMS regardless of impedence due to the X-flow technology. £250 ono http://www.phoenixgold.com/2004/images/xenon/amplifiers/x1200.1.jpg http://www.phoenixgold.com/2004/xenonamps.html 5.) Image Dynamics IDmax12D4 v3 High Excursion 12" sub-woofer, 250-1000w RMS, dual 4ohm coils. Brand new, still in the box. Looking for £250 http://www.imagedynamicsusa.com/graphics/tech/tech2_idmax.gif http://www.imagedynamicsusa.com/tech_page.php?name=IDMAX12D4%20V.3&type=sub&id=idmax 6.) Phoenix Gold Titanium Elite 6.5" components Wonderful speakers, I had them coupled to the 600.2 amp in my Celica but haven't used them since. Used to retail for about £900 several years ago. Looking for £175 ono http://www.phoenixgold.com/2004/images/tielite/TiElite_6comp.jpg From Car-Domain:Titanium Elite series components are unlike anything available before. If you want a speaker with the ultimate in sound and build quality available for the automobile, then the Titanium Elite series drivers are for you. With unique features like neodymium magnets and audiophile-grade dual mono crossover, these components are destined for classic status among high-end component speakers. Only Titanium Elite components offer these amazing technologies: * Custom tooled, cast aluminum basket ensures an ultra-rigid assembly * Basket venting for increased power handling and lower distortion * Contoured vent hole for reduced vent noise * Hybrid, custom tooled terminals accept large gauge wire * Optimized stepped spider controls cone motion without limiting excursion * High-grade neodymium iron boron (NeFeB) magnet allows for thin mounting depth * FEA computer optimized pole and top plate strike a balance between excursion and control * Ultra low carbon pole piece has higher magnetic conductance than lesser materials * Ultra low carbon, FEA optimized magnetic return cup precisely aligns the magnetic gap * One piece polypropylene cone and dustcap assembly for higher rigidity * Blue anodized, vented aluminum voice coil former handles higher power while remaining cool * Multi-layer, lightweight, 3" high temp aluminum voice coil dissipates heat better than copper voice coils * Optimized butyl rubber surround is designed specifically for the Titanium Elite series * Single stereo crossover assembly features audiophile-grade components such as hand-wound air core inductors, Mylar capacitors, and a unique illuminated attenuation circuit. * 28mm textile dome tweeters are hand doped for precise balance * Integral tweeter wave guides provide wide, even dispersion Link to comment Share on other sites More sharing options...
ECK Posted March 4, 2007 Share Posted March 4, 2007 Link to comment Share on other sites More sharing options...
Bob Posted March 4, 2007 Author Share Posted March 4, 2007 PM'd back Link to comment Share on other sites More sharing options...
Bob Posted March 4, 2007 Author Share Posted March 4, 2007 Added components as well. Link to comment Share on other sites More sharing options...
Recommended Posts