Wipeout Posted May 2, 2004 Share Posted May 2, 2004 OK, after reading the search results, I want to clear a few things up. I will be doing a front pad change and fluid change. UK Spec Manual. I have the pads (stock) and 1.5L Motul RBF 600. Do I need to buy a shim fitting kit? I want it to be easy as possible! I found these part numbers, are they correct for UK Fronts? 04947-14010 Fitting kit - £10.40 04945-14110 Shim kit - £9.94 Posted Matt.H. I see that some of you recommend removing the squeal shim from the pads, is this required or just personal choice, does it improve things? (They seem hard and good at the moment) Next is the fluid change. I found a post about bleeding the trac system when doing the brakes, this is the bit that sounds fun!! Is this required? obviously it is, but being no expert on this, it might be disastrous. Are there any clear idiot proof instructions out there? or tricks that I might need to know when doing it. I was hoping to just keep bleeding the new fuild through, the same way i have done in the past on other cars. Thanks in advance Quote Link to comment Share on other sites More sharing options...
dangerous brain Posted May 3, 2004 Share Posted May 3, 2004 If you need a pressure bleed kit with the universal bayonet fit cap gimme a shout as I have one. Quote Link to comment Share on other sites More sharing options...
Wipeout Posted May 3, 2004 Author Share Posted May 3, 2004 Cheers Bryan. I will keep that in mind, i should be ok though as my mate is a mechanic and hopfully has all the bits and pieces. Quote Link to comment Share on other sites More sharing options...
dangerous brain Posted May 3, 2004 Share Posted May 3, 2004 Cool you sounded like you were doing this job with your home tool kit and mine is very comprehensive but didnt have the bayonet cap fitting for my bleed kit. I had to buy a seperate cap which disgustingly cost more than the original bleed kit itself. Quote Link to comment Share on other sites More sharing options...
Wipeout Posted May 3, 2004 Author Share Posted May 3, 2004 No point getting my hands dirty if he's willing to do it for me, but i if he's busy i may tackle it myself. Hopefully he won't be Cheers. Does anyone have some useful info on what i might need to know when doing this. Thanks. Quote Link to comment Share on other sites More sharing options...
Wipeout Posted May 6, 2004 Author Share Posted May 6, 2004 BTT Anyone?? Usefull need to know stuff when doing pads and bleed UK Trac. Thanks. Quote Link to comment Share on other sites More sharing options...
Wipeout Posted May 10, 2004 Author Share Posted May 10, 2004 BTT Anyone??? Quote Link to comment Share on other sites More sharing options...
SimonB Posted May 10, 2004 Share Posted May 10, 2004 Well I reused the shims etc when I did mine. Very easy job (as long as the pins haven't corroded). Just put some copper grease on the back of the pads/shims before putting the new ones in to stop them squeeling. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.