Hak Posted May 17, 2006 Share Posted May 17, 2006 Hi all, I need to change the number plate on my Jap supra from square to rectangle (for a private plate). Has anyone done this before? And if so do you have any tips? There seems to be a big gap behind the rear plate which needs to be filled somehow e.t.c. Thanks Link to comment Share on other sites More sharing options...
michael Posted May 17, 2006 Share Posted May 17, 2006 Might be easier to buy a UK bumper. Link to comment Share on other sites More sharing options...
Nic Posted May 17, 2006 Share Posted May 17, 2006 I have seen checker plate used to fill the hole at the back, although not something I would personally use. Link to comment Share on other sites More sharing options...
Ian W Posted May 17, 2006 Share Posted May 17, 2006 i've just got a mahoosive rectangular plate on mine, mate. Link to comment Share on other sites More sharing options...
Hak Posted May 17, 2006 Author Share Posted May 17, 2006 i've just got a mahoosive rectangular plate on mine, mate. Mahoosive! I like it! I just phoned a shop regarding one of those. Could u tell me the dimensions pls. nice1. Link to comment Share on other sites More sharing options...
Ian W Posted May 17, 2006 Share Posted May 17, 2006 it's approximately 6" x 20" (maybe 21") pic in my Garage mate. Link to comment Share on other sites More sharing options...
Guest jbk Posted May 17, 2006 Share Posted May 17, 2006 Hi folks, first post hope its useful, cut a sheet of thinnish ally just slightly smaller than inset bumper panel, round off corners and deburr, prime and spray to body colour, drill two holes under where the new plate will go and use self tapping screws and possibly a couple of self adhesive pads to stop any rattling. screw uk plate into this. cheaper than new bumper and looks good. Link to comment Share on other sites More sharing options...
Ian W Posted May 17, 2006 Share Posted May 17, 2006 Hi folks, first post hope its useful, cut a sheet of thinnish ally just slightly smaller than inset bumper panel, round off corners and deburr, prime and spray to body colour, drill two holes under where the new plate will go and use self tapping screws and possibly a couple of self adhesive pads to stop any rattling. screw uk plate into this. cheaper than new bumper and looks good. not bad although it'd be more useful with pictures welcome btw Link to comment Share on other sites More sharing options...
Guest jbk Posted May 17, 2006 Share Posted May 17, 2006 When it stops raining Link to comment Share on other sites More sharing options...
Guest jbk Posted May 17, 2006 Share Posted May 17, 2006 Rain stopped, here is a pic, bit difficlt to see where the plate overlays the bumper on a black car but thats the point really, the measurement on the pic is the ally plate size and fits over the flat area of the bumper. radiusing the corners makes it fit nicely, make a dummy in cardbord first to make sure it covers the large hole top to bottom. Link to comment Share on other sites More sharing options...
Guest jbk Posted May 17, 2006 Share Posted May 17, 2006 Sorry, Pic here hopefully size is 51cm x 16.5 cm Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now