Ibrar Jabbar Posted May 9, 2006 Share Posted May 9, 2006 Is it advisable to surface grind standard shims to gain correct tolerances for valve adjustment? or do I have to buy new from Toyota? I need 2.50, 2.55, 2.60 and 2.65 mm shims. Link to comment Share on other sites More sharing options...
Guest Terry S Posted May 9, 2006 Share Posted May 9, 2006 buy new shims, were the HKS cams a long way out? BTW I know Mark at Phoenix has a load of 2.5mm as someone's car is with him, and the tuner, has installed 2.5mm shims in every bucket... Link to comment Share on other sites More sharing options...
Ibrar Jabbar Posted May 9, 2006 Author Share Posted May 9, 2006 I have clearance on 2 valves on the inlet and 3 valves on the exhaust and that's it. All the others have zero clearance. So what you saying Terry some tuner has fitted 2.5mm shims without even checking tolerances? Link to comment Share on other sites More sharing options...
Guest Terry S Posted May 9, 2006 Share Posted May 9, 2006 So what you saying Terry some tuner has fitted 2.5mm shims without even checking tolerances? LOL yeah but they clearly think all the shims should be the same size. It sounded like a bag of nails! Link to comment Share on other sites More sharing options...
JohnA Posted May 12, 2006 Share Posted May 12, 2006 Is it advisable to surface grind standard shims to gain correct tolerances for valve adjustment? ... I'd never do this. You risk accelerated wear of the shim later on, or (worst case scenario) a shattered shim. Brrrrrr....... Link to comment Share on other sites More sharing options...
Ibrar Jabbar Posted May 12, 2006 Author Share Posted May 12, 2006 Thanks John, I have ordered new ones from Toyota, I'm hoping they turn up tommorow so I can finish everything off. Link to comment Share on other sites More sharing options...
JohnA Posted May 13, 2006 Share Posted May 13, 2006 It's also best to measure clearances *after* valve seats etc have been cleaned, lapped and the like. In some cases lapping can lead to the need for a different shim (valve moves closer to the cam) Have them double-check valve clearances *again* after the new shims are in place. You never know. Clearances that are abnormally small can lead to burnt valves later on. Link to comment Share on other sites More sharing options...
Ibrar Jabbar Posted May 13, 2006 Author Share Posted May 13, 2006 Thanks for the advice John. I had a 3 angle exhaust and 5 angle inlet valve job and the HKS cams, which probably explains why I had little or no clearance. I am doing all the work myself and being very thorough. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now