GazzaGSi Posted January 12, 2006 Share Posted January 12, 2006 Hi all, If I was to change the coolant sensor would I need to drain the coolant or can I just swap the sensors over? Would i need to reset the ECU afterwards too? Could do with knowing asap please. Thanks alot Gaz (its a J-Spec N/A Manual.) Quote Link to comment Share on other sites More sharing options...
merckx Posted January 12, 2006 Share Posted January 12, 2006 Just take it out and put the new one in, you should only lose a little coolant and then top it up if necessary. No need to reset ECU. Quote Link to comment Share on other sites More sharing options...
GazzaGSi Posted January 12, 2006 Author Share Posted January 12, 2006 Thankyou Quote Link to comment Share on other sites More sharing options...
Dazzi Posted August 22, 2008 Share Posted August 22, 2008 Sorry to bring this back but where is the temp sensor on the na? I saw a toyota diagram that its on the right side of the engine but can't see it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.