dave barratt Posted December 23, 2005 Share Posted December 23, 2005 Any members no were I can get hold of some clear sticky back plastic to put underneath the rear quarter moldings to stop stone chippings Link to comment Share on other sites More sharing options...
SupraStar 3000 Posted December 23, 2005 Share Posted December 23, 2005 any local sign shop will sell you vinyl Link to comment Share on other sites More sharing options...
merckx Posted December 23, 2005 Share Posted December 23, 2005 I got some from Demon Tweeks, not easy to apply when you've got a 3d curve though. Link to comment Share on other sites More sharing options...
Gordon F Posted December 23, 2005 Share Posted December 23, 2005 I got some from Demon Tweeks, not easy to apply when you've got a 3d curve though. Put it on 'wet' and then you can move it about a bit until it is in the right place. Then dry it off with a hairdryer and get rid of any excess fluid under the film with a felt squeegee that you can get from most vinyl shops. I use this stuff to apply stickers / heli tape. Link to comment Share on other sites More sharing options...
merckx Posted December 23, 2005 Share Posted December 23, 2005 I couldn't really get it shaped to the curve though without making some release cuts for the bulges in the plastic where you have a compound curve. I'm not sure if heat would have helped , the material was fairly thick. Link to comment Share on other sites More sharing options...
SupraStar 3000 Posted December 23, 2005 Share Posted December 23, 2005 Put it on 'wet' and then you can move it about a bit until it is in the right place. Then dry it off with a hairdryer and get rid of any excess fluid under the film with a felt squeegee that you can get from most vinyl shops. a credit card wrapped in kitchen roll will do for a squeegee Use warm (not hot) water with a very small amount of fairy liquid Link to comment Share on other sites More sharing options...
peter richards Posted December 23, 2005 Share Posted December 23, 2005 blue peter Link to comment Share on other sites More sharing options...
dave barratt Posted December 24, 2005 Author Share Posted December 24, 2005 Thanks for all the advice guys. A Merry Christmas and a Happy New Year. Hope to meet up with some of you in the new year. Anyone in the Derby area? Link to comment Share on other sites More sharing options...
SupraStar 3000 Posted December 24, 2005 Share Posted December 24, 2005 Loughborough, next door. Look in the event section early new year. We have a few events planned in the midlands Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now