1st useful 3D printed piece

[Big Mark]

A friend tried to scan them but software was rubbish, so I just measured carefully and used 2d prints of my sketches to make sure everything was aligned to the originals where necessary.

[Big Mark]

1 hour ago, SupraTRD_MK4 said:

@griffsplace ah I see noted mate. Maybe I will trouble you for some later. Still no idea what I am gona do yet.

@Big Markthat really looks good mate. What did it set you back to make them? Modelling time, electricity, plastic material? Those look great. Remember when I was hunting them in Japan for my RZ model as Toyota told me its discontinued.

Will await the final piece after you done. Your flappy pedals are for the tip tronic RZ setup? Or you running a BMW DCT trans?

No idea on costs as I wasn't keeping a track of my time and I can't remember the printing cost, but it was mates rates.  Tho the lower cowl was almost a 36 hour print.  Plus it was a fraction too tall for his Prusa so I moddelled a joint into it so it could be printed in 2 parts and then seamlessly joined.

[SupraTRD_MK4]

On 9/16/2021 at 3:02 PM, Big Mark said:

No idea on costs as I wasn't keeping a track of my time and I can't remember the printing cost, but it was mates rates.  Tho the lower cowl was almost a 36 hour print.  Plus it was a fraction too tall for his Prusa so I moddelled a joint into it so it could be printed in 2 parts and then seamlessly joined.

Nice work mate. Congrats once again. Any chance you would share the diagrams you made or is there a fee for your hard work?

 

 

[Nathanj1142]

nowhere near as impressive as what you guys have done, but I 3d printed these brackets for my fuel lines lol

Edited September 21, 2021 by Nathanj1142 (see edit history)