renegade Posted January 9, 2019 Share Posted January 9, 2019 (edited) what all has to be done to remove the door weather strip. does it just pull off? is there any screws Edited January 9, 2019 by renegade (see edit history) Quote Link to comment Share on other sites More sharing options...
P_Bazz Posted January 9, 2019 Share Posted January 9, 2019 (edited) Lower the windows and pull off the door cards, there are two screws that hold them to the door. Be sure to use the right size screwdriver as they will easily strip and you cannot replace them with normal bolts as they will hit/scratch the glass when going up and down. Another method is to make a notch with a small chisel and carefully hammer them in a anti-clockwise fashion if they do happen to strip. (Part no. 90154-60027) Edited January 9, 2019 by P_Bazz (see edit history) Quote Link to comment Share on other sites More sharing options...
renegade Posted January 9, 2019 Author Share Posted January 9, 2019 I have the new parts75720 and 75710. so take door cards off then? Quote Link to comment Share on other sites More sharing options...
P_Bazz Posted January 9, 2019 Share Posted January 9, 2019 I have the new parts75720 and 75710. so take door cards off then? Exactly. The part no. I mentioned was for the screws. Don't try and push the weatherstrips down to hard either, they always stick up a little bit. Just match them with the trim part on the rear quarter windows in height. Quote Link to comment Share on other sites More sharing options...
Rob W Posted January 9, 2019 Share Posted January 9, 2019 Yes remove the door card. 2 screws holding them on, 1 at each end IIRC. Quote Link to comment Share on other sites More sharing options...
renegade Posted January 11, 2019 Author Share Posted January 11, 2019 got the drivers side done. other side not so good screws not moving put lots of wd40 on not sure if they will come out whole. Quote Link to comment Share on other sites More sharing options...
SupraTRD_MK4 Posted January 11, 2019 Share Posted January 11, 2019 Can you post a photo of the screw pls? Someone? Quote Link to comment Share on other sites More sharing options...
renegade Posted February 16, 2019 Author Share Posted February 16, 2019 Quote Link to comment Share on other sites More sharing options...
renegade Posted February 16, 2019 Author Share Posted February 16, 2019 got it out had to use centre punch Quote Link to comment Share on other sites More sharing options...
mwilkinson Posted February 16, 2019 Share Posted February 16, 2019 I've had the horror of those screws in the past. Ended up having to drill one out. Glad the punch worked for you. Quote Link to comment Share on other sites More sharing options...
evinX Posted February 16, 2019 Share Posted February 16, 2019 All you gotta do is get a fitting phillips. Give them 2 good hits with a deadblow to 'crack em' and they come out normally. Quote Link to comment Share on other sites More sharing options...
The Raven Posted February 17, 2019 Share Posted February 17, 2019 Out of interest how much where the parts Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.