Jellybean Posted November 30, 2015 Share Posted November 30, 2015 Nice price point http://www.haltech.com/elite-750-unveiled-at-sema/ Product: Elite 750 ECU Part Number: HT150600 MSRP (North America): USD $1199 RRP (Australia inc GST): AUD $1495 On Sale: Early 2016 Features: • Waterproof Case (IP67) • 34 Position AMP connector • 6 x Fuel Injection Outputs • 6 x Ignition Outputs • 5 x Digital Outputs • 5 x Analogue Voltage Inputs • 2 x Digital Pulsed Inputs • USB Laptop Communications up to 1 MB/s • 2 x Engine Position Inputs with extensive trigger type support • ESP Calibration Software – Intuitive and easy to use • CAN Bus communication for Haltech CAN Expansion • User definable tables • Multi-fuel Support – Support for Petrol (Gasoline), LPG, Methanol and Ethanol • E85 Flex Fuel Ready – Direct connection to sensor • Closed Loop 02 Control • On-board Data Logging • ECU comes fully enabled, no additional charges for advanced features • 1 to 8 Cylinder engines or 1 to 3 rotor engines • Normally aspirated or forced induction • Load sensing by Throttle Position (TPS), Manifold Absolute Pressure (MAP) or Mass Air Flow (MAF) • In-built 29PSI MAP Sensor • Sequential, semi sequential, batch or multipoint injection patterns • Distributor ignition systems, multi-coil systems or Haltech Multiplex CDI systems Inputs and Outputs: Fuel Injectors: 6 x Peak & Hold injector drivers Ignition: 6 x Over current protected ignition drivers Analogue Voltage Inputs : 5 x Analogue Voltage Inputs Synchronised Pulsed Inputs: 2 Digital Pulsed Outputs : 5 x over-current protected low side pulsed outputs Internal MAP Sensor : 3 Bar internal MAP sensor Supports up to 200Kpa of boost (2Bar/29psi) Technical Specifications: Input Supply Voltage : 8VDC to 16VDC Output Sensor Supply Maximum Current Ratings: 5V Supply: 100mAMax Quote Link to comment Share on other sites More sharing options...
mattdavies Posted November 30, 2015 Share Posted November 30, 2015 Not that I know much about ECU's but that comes across as a good entry level ECU for a Supra. and a very reasonable price if you take the USD price as GBP price including import tax. I am sure there is then a loom to add and I wonder what additional sensors it needs. Quote Link to comment Share on other sites More sharing options...
Jellybean Posted November 30, 2015 Author Share Posted November 30, 2015 I was quoted 2300 euro for the PS2000 fitted/mapped with a patch harness , if I wanted additional sensors like Boost, knock, Lambda and oil pressure it was extra I reckon this will come in the 1800 euro mark Quote Link to comment Share on other sites More sharing options...
LasseV Posted November 30, 2015 Share Posted November 30, 2015 I was quoted 2300 euro for the PS2000 fitted/mapped with a patch harness , if I wanted additional sensors like Boost, knock, Lambda and oil pressure it was extra I reckon this will come in the 1800 euro mark Well, that sounds reasonable priced Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.