mattdavies Posted August 12, 2015 Share Posted August 12, 2015 I noticed that most people use silicone joiners on their intercooler set ups, but the OEM set up uses rubber. Whats the reason for this is it the bling factor or is silicone a better joiner ? Link to comment Share on other sites More sharing options...
Chris Wilson Posted August 13, 2015 Share Posted August 13, 2015 The silicone may have a higher burst pressure, but as I have never seen a stock pipe or pipe joiner burst it is irrelevant. the silicone pipes vary from excellent to utter junk, like most aftermarket stuff. OE rubber is less likely to blow off as silicone is much more slippery. As an aside people who fit "hard pipe" kits thinking they improve spool need to read their physics books, they make no difference whatsoever, and are purely a wallet opening exercise. Link to comment Share on other sites More sharing options...
mattdavies Posted August 13, 2015 Author Share Posted August 13, 2015 Thank you Chris this was the answer i was looking for. I think then I will try replace the silicone bits I have with Rubber where possible. Does anyone know if rubber reducers are available ? Link to comment Share on other sites More sharing options...
j_jza80 Posted August 13, 2015 Share Posted August 13, 2015 As an aside people who fit "hard pipe" kits thinking they improve spool need to read their physics books, they make no difference whatsoever, and are purely a wallet opening exercise. I fitted a hardpipe kit as: 1) Was fitting a new SMIC, so it was pretty straight forward to do 2) figured that replacing the stock basic jubilee clips with constant tension clamps was probably a good idea for raised boost pressures. 3) the stock intercooler hose that sits behind the airbox, and the one that connects to the throttle both deteriorate badly with age and heat, and Iv'e seen several that contact badly. Link to comment Share on other sites More sharing options...
Chris Wilson Posted August 13, 2015 Share Posted August 13, 2015 Are you having issues with silicone couplers blowing off? There are some tricks of the trade that should help, if so. Link to comment Share on other sites More sharing options...
mattdavies Posted August 13, 2015 Author Share Posted August 13, 2015 I am not, Just have some cheap replacements that were to do me for a short while. I have now got to the point where I am looking to replace them so I was thinking do I go Silicone or go OEM Rubber Link to comment Share on other sites More sharing options...
Dnk Posted August 13, 2015 Share Posted August 13, 2015 (edited) You can get Samco Silicon hose couplers for very sensible price from http://www.merlinmotorsport.co.uk Swaged ends on the pipes usually does the trick with decent clamps, I used the Mikalors on my car and never had a problem, hair spray can also assist in stopping hoses popping off Edited August 13, 2015 by Dnk (see edit history) Link to comment Share on other sites More sharing options...
MRX Posted August 13, 2015 Share Posted August 13, 2015 Dont suppose you know the part number for the OEM hose that goes from IC into the Inlet Manifold? I need a new one of them... Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now