pete.osborne69 Posted December 13, 2014 Share Posted December 13, 2014 How has everybody managed to get a socket and extension bar in the gap to get the bolts off the first decat Link to comment Share on other sites More sharing options...
Ian Ian Posted December 13, 2014 Share Posted December 13, 2014 Work from underneath with a long exstension bar ...they are known to be tight and rusty depending on the condition of the car or how well its been maintained etc Cheers -Ian- Link to comment Share on other sites More sharing options...
Scoot Posted December 13, 2014 Share Posted December 13, 2014 I was underneath the car with an extension and elbow. And it took me a few hours of soaking with penetrative spray as I had no heat. Just don't snap them! Link to comment Share on other sites More sharing options...
Marcus GTE Posted December 13, 2014 Share Posted December 13, 2014 (edited) Double post Edited December 13, 2014 by Marcus GTE (see edit history) Link to comment Share on other sites More sharing options...
Marcus GTE Posted December 13, 2014 Share Posted December 13, 2014 ^ this 2 can be accessed straight on, one you will need the elbow. Make sure it's fully on before turning. Good luck Ps you might find the bolts between cats and on the exhaust bracket are in worse condition so be sure you can deal with them before going to all the hassle of getting the tough 3 off. I had to cut some Link to comment Share on other sites More sharing options...
pete.osborne69 Posted December 13, 2014 Author Share Posted December 13, 2014 Thanks for all of your replies I have finally managed to do it On a slightly other note has anyone done a read up with images for fitting the Greddy profec boost controller (new style) I usually find that a guide on here is usually easier to understand than a manual That and I can compare the pictures to my car to see how everything is set up I am aware that there is instructions on the Greddy website but I don't know where everything is in the engine bay yet and its not car specific Any help or pointers would be appreciated Thanks all Pete Link to comment Share on other sites More sharing options...
Scoot Posted December 13, 2014 Share Posted December 13, 2014 Thanks for all of your replies I have finally managed to do it On a slightly other note has anyone done a read up with images for fitting the Greddy profec boost controller (new style) I usually find that a guide on here is usually easier to understand than a manual That and I can compare the pictures to my car to see how everything is set up I am aware that there is instructions on the Greddy website but I don't know where everything is in the engine bay yet and its not car specific Any help or pointers would be appreciated Thanks all Pete Most boost controller installs are the same, There's an article on MKIV that should show where you need to put bits. Link to comment Share on other sites More sharing options...
pete.osborne69 Posted December 13, 2014 Author Share Posted December 13, 2014 Thanks will have a look tomorrow when I have enough light to start fitting it Link to comment Share on other sites More sharing options...
Scoot Posted December 13, 2014 Share Posted December 13, 2014 http://mkiv.com/techarticles/blitz_dsbc/index.html I followed this when it came time to do mine. Up to you where you take power from. Link to comment Share on other sites More sharing options...
pete.osborne69 Posted December 17, 2014 Author Share Posted December 17, 2014 I have managed to do it last weekend was a pita but I managed it in the end Thanks all Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now