msupra1 Posted February 3, 2014 Share Posted February 3, 2014 Ok so I have a 1995 RZ Supra that came with factory Recaro seats. The seats are in bad condition so I have decided sell them off. I just got some stock cloth seats. I was about to install them today. I noticed that the black socket for the seat belt is there. The 2nd larger white socket for the seat hook-up, this car does not have it. Without that, I am unable to move the electric slider rails and adjust the seat. The position it is in right now makes it difficult to install as well. So if this Supra does not have that plug, what are my options to somehow hook this seat up to make these electric rails work? From searching most results are about the rails not working. In my case this Supra does not have the socket for the seats to begin with. So I am a bit lost. Any help will be great! Quote Link to comment Share on other sites More sharing options...
SPG Posted February 3, 2014 Share Posted February 3, 2014 You are going to need a section of the loom from a car with electric seats fitted, then you are going to have to splice into your existing interior loom. I would suggest you seriously consider refurbishing your Recaro's. Quote Link to comment Share on other sites More sharing options...
David P Posted February 3, 2014 Share Posted February 3, 2014 The seat can be wound back and forth using a socket on the end of the motors rod. Quote Link to comment Share on other sites More sharing options...
supraGZaerotop Posted February 3, 2014 Share Posted February 3, 2014 can the recaros not be retrim Quote Link to comment Share on other sites More sharing options...
2soops Posted February 3, 2014 Share Posted February 3, 2014 Have you checked under the carpet as the connector your looking for may have been tucked away by a previous owner. Quote Link to comment Share on other sites More sharing options...
msupra1 Posted February 3, 2014 Author Share Posted February 3, 2014 (edited) The seat can be wound back and forth using a socket on the end of the motors rod. That may work to have the seats positioned for me to drive the car.. but its going to be a problem to mount them in the car. To mount the back bolts for example the seat needs to be fully reclined forward The seats are already gone and I have these cloth seats. They were bad to the point that they needed a full reholster ahh well I'll have to try and figure this out Regards Edited February 3, 2014 by msupra1 (see edit history) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.