LOGIE Posted October 19, 2013 Share Posted October 19, 2013 I don't think this qualifies as mkiv technical..? Tomorrow I'm going to put the engine loom through the firewall, I KNOW this will be a bit of a pain and fiddly has anyone got any hints to making this easier? Link to comment Share on other sites More sharing options...
absz Posted October 19, 2013 Share Posted October 19, 2013 I use a welding wire attached to one of the plugs and gently feed it in. also helps if you remove the heater resistor module Link to comment Share on other sites More sharing options...
Swampy442 Posted October 19, 2013 Share Posted October 19, 2013 I used 2 people, its much easier that way. Link to comment Share on other sites More sharing options...
Rich.2211 Posted October 19, 2013 Share Posted October 19, 2013 (edited) I must of been lucky as I just fed it through the hole in the bulk head, jiggled it and looked under the dash to find the loom had appeared. A metal coat hanger could be a useful tool to help you out. Edited October 19, 2013 by Rich.2211 (see edit history) Link to comment Share on other sites More sharing options...
Homer Posted October 19, 2013 Share Posted October 19, 2013 I must of been lucky as I just fed i through the hole in the bulk head, jiggled it and looked under the dash to find the loom had appeared. A metal coat hanger could be a useful tool to help you out. This is how I did it too, it's quite an easy job, good luck Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now