Big Mark Posted September 29, 2013 Share Posted September 29, 2013 I know under the front of the car there are two undertrays but where the two meet does anyone know what attaches them two together and/or to the underside of the car? Mine just had cable ties tying them to each other but I think the last garage didn't replace them when they did the last oil change so one is dropping down and scraping over bumps so thought I'd get the proper parts and fasten them properly. Does anyone know what I need? Link to comment Share on other sites More sharing options...
Lee P Posted September 29, 2013 Share Posted September 29, 2013 The bumper undertray and engine under tray bolt together to the front crossmember Link to comment Share on other sites More sharing options...
Scooter Posted September 29, 2013 Share Posted September 29, 2013 and from memory the engine covers front edge tucks up under the rear of the engine cover No.2 in the pic. If they are cable tied together, unless someones been really lazy, I would strongly suspect if you remove the covers you will see the remains of sheared bolts in the front cross member... Link to comment Share on other sites More sharing options...
Dnk Posted September 29, 2013 Share Posted September 29, 2013 While your under there have a good look at the cross member as they're prone to rotting quite badly Link to comment Share on other sites More sharing options...
girth45 Posted September 29, 2013 Share Posted September 29, 2013 Hi mark, replaced mine for an srd one, really pleased. But had to drill out most of the snapped bolts. Oh and finished the bpu on mine and fitted BC coilovers. Link to comment Share on other sites More sharing options...
Big Mark Posted September 29, 2013 Author Share Posted September 29, 2013 Thanks guys. The car is going up on ramps tomorrow after work so I'll have a good look and see what's what. Link to comment Share on other sites More sharing options...
Big Mark Posted September 29, 2013 Author Share Posted September 29, 2013 Hi mark, replaced mine for an srd one, really pleased. But had to drill out most of the snapped bolts. Oh and finished the bpu on mine and fitted BC coilovers. I bet you're loving being BPU'd. How's the Coilovers, are they a lot firmer compared to stock? Link to comment Share on other sites More sharing options...
girth45 Posted September 29, 2013 Share Posted September 29, 2013 Coilovers are great, set dampers mid way feels really planted. Link to comment Share on other sites More sharing options...
Big Mark Posted September 29, 2013 Author Share Posted September 29, 2013 How much firmer is it compared to stock? Link to comment Share on other sites More sharing options...
girth45 Posted September 29, 2013 Share Posted September 29, 2013 I can set it up to be softer or harder than stock on the damping, and adjust ride heights so can add a bit of rake, highly recommend them. If your interested come out for a drive and see what you think. Link to comment Share on other sites More sharing options...
Big Mark Posted September 29, 2013 Author Share Posted September 29, 2013 Sounds like a plan. We have to arrange to meet up again, we've been on about it for ages now! Link to comment Share on other sites More sharing options...
girth45 Posted September 29, 2013 Share Posted September 29, 2013 Pm me your mob, will call tomorrow. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now