scott.wild Posted September 25, 2013 Share Posted September 25, 2013 Hi, has anyone done this before? I am thinking a standard toad auto closure module will handle the closing and then using a second one connected to one of the other alarm outputs to handle total window opening. I am only interested in having the drivers side do this. The goal is to make it a little easier when getting in/out of tight spots. Also is it possible to have an automatic boot release from the alarm? Thanks Link to comment Share on other sites More sharing options...
scott.wild Posted September 29, 2013 Author Share Posted September 29, 2013 Hi, quick up date, I have managed to get total closure on both windows working with driver side opening on demand now for the boot release. Link to comment Share on other sites More sharing options...
SupraP-Z Posted September 29, 2013 Share Posted September 29, 2013 It is possible to have a boot release, atleast it has the capabilities anyway. My toad alarm is fubar Link to comment Share on other sites More sharing options...
Abz Posted September 30, 2013 Share Posted September 30, 2013 Yep it is possible to have the boot release, not sure on the Toad but I have it setup on my Clifford. Basically need a remote solenoid keyed into your fob. Link to comment Share on other sites More sharing options...
mattdavies Posted September 30, 2013 Share Posted September 30, 2013 Hi, how do you get total closure on your alarm. I have the same alarm and would like to add this ? Is it an extra module that needs wiring in ? Is it fairly straight forward to get to work v Link to comment Share on other sites More sharing options...
scott.wild Posted October 1, 2013 Author Share Posted October 1, 2013 Hi, For the total closure you need a an extra module, toad PWC-402 or something similar that triggers from the white negative feed wire from your alarm. Wiring up is fairly straight forward although a little awkward. I chose to run a new positive fused cable from the battery which gives power for the module, from the module there are 4 wires which need to be fed to the drivers door window switch. It's then just a matter of cutting an existing wire that goes to the driver motor, solder each end of this to the pair of wires from the module, do the same for the passenger window. I did a dry fit first and did a few diagrams because i was adding a second module to handle driver window opening. Once it was all working tidy up the cables and solder and heat shrink all the wires. I have also added remote boot release now as well Link to comment Share on other sites More sharing options...
straightsix Posted October 2, 2013 Share Posted October 2, 2013 I have also added remote boot release now as well Has Ed seen this???? Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now