Marco79 Posted November 19, 2012 Share Posted November 19, 2012 Im fitting low impedance injectors and need a resistor pack, does anyone know how to make these? I've had a search but not found much info Link to comment Share on other sites More sharing options...
Nic Posted November 19, 2012 Share Posted November 19, 2012 You could source a UK spec resistor pack part number 28510-46020 Link to comment Share on other sites More sharing options...
Paul Whiffin Posted November 20, 2012 Share Posted November 20, 2012 I have a uk spec resistor pack if needed? Link to comment Share on other sites More sharing options...
Nodalmighty Posted November 20, 2012 Share Posted November 20, 2012 There are two ways of doing this, the first is a voltage resistor tree like stock and the other is in line with the injector ecu feeds. For neatness the factory RP is a good piece of kit but a total bugger to wire into the main loom due to the sheer number of black and orange wires and as it's a power feed they are all linked so a continuity test is no good to you. You wouldn't be the first to connect a resistor pathway to a coil pack The in line method requires 6 x 4.7ohm 50watt resistors (Farnell or Maplin). This should combine with the LI injectors to give about 8 ohms per channel (anything above 6 ohms is good, but any more than 8 defeats the whole point of the faster response time of the LI injector). Lyndon. Link to comment Share on other sites More sharing options...
Kev.O Posted November 20, 2012 Share Posted November 20, 2012 Mark, the inline way seems to be how the existing loom you have was configured, judging by the way the cables are arranged and cut. Link to comment Share on other sites More sharing options...
Marco79 Posted November 20, 2012 Author Share Posted November 20, 2012 (edited) The in line method requires 6 x 4.7ohm 50watt resistors (Farnell or Maplin). This should combine with the LI injectors to give about 8 ohms per channel (anything above 6 ohms is good, but any more than 8 defeats the whole point of the faster response time of the LI injector). Lyndon. Mark, the inline way seems to be how the existing loom you have was configured, judging by the way the cables are arranged and cut. Online option seems the way forward thanks guys Edited November 20, 2012 by Marco79 Stupid question (see edit history) Link to comment Share on other sites More sharing options...
Marco79 Posted November 20, 2012 Author Share Posted November 20, 2012 All sourced and ordered from RS Link to comment Share on other sites More sharing options...
TT Paul Posted November 20, 2012 Share Posted November 20, 2012 heckler makes em got one fitted Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now