Hellstrom Posted May 18, 2012 Share Posted May 18, 2012 Hi, Can anyone confim that when ignition turned on the solinoid should switch to shut mode? also what voltage is required for it to shut? iam reading 1.5volt on the plug to the soliniod but it dont shut, however when feeding it with 12v from the battery it switched to shut. any ideas? Regards Johan Quote Link to comment Share on other sites More sharing options...
Hellstrom Posted May 19, 2012 Author Share Posted May 19, 2012 Anyone? Quote Link to comment Share on other sites More sharing options...
Hellstrom Posted May 19, 2012 Author Share Posted May 19, 2012 Sorted Quote Link to comment Share on other sites More sharing options...
CanisLupus Posted May 19, 2012 Share Posted May 19, 2012 Hi mate! What was the solution? How is the Solenoid supposed to be working? I have to test mine too as i am not sure if it is working like it should. Quote Link to comment Share on other sites More sharing options...
Hellstrom Posted May 19, 2012 Author Share Posted May 19, 2012 Its controlled with earth from the main unit, i took the solenoid apart and cleand it also rewired the whole lot as it was done badly. Quote Link to comment Share on other sites More sharing options...
CanisLupus Posted May 19, 2012 Share Posted May 19, 2012 Ok and is there any Start up sequence? Klicking when turning on the ignition etc? What Voltage should i see? Quote Link to comment Share on other sites More sharing options...
Hellstrom Posted May 19, 2012 Author Share Posted May 19, 2012 Yeah click when ig on. Its easy i check the solenoid it self if you have compressed Air. Just put some compressed Air to the vacum switch/boost sensor. And the acutator should start working Quote Link to comment Share on other sites More sharing options...
Hellstrom Posted May 19, 2012 Author Share Posted May 19, 2012 Think i had 1.45v messured between the 2 pols of the connector. 1one should have 12v when earthed and the earth had aprox 100ohm resustence iirc Quote Link to comment Share on other sites More sharing options...
CanisLupus Posted May 21, 2012 Share Posted May 21, 2012 Thanks! Works a treat ^^ Quote Link to comment Share on other sites More sharing options...
Sukhy Posted May 21, 2012 Share Posted May 21, 2012 Just a side note, my greddy profec A solinoid makes a clicking noise constantly when the ignition is on 1 notch before starting.. Should it be doing this. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.