Jamesy Posted April 26, 2012 Share Posted April 26, 2012 As im stripping my Supra i now have the uprated SRD engine for sale. This was built by SRD last year to a very high standard and is all but a fully built engine except the oem rods and pistons, which are very strong and will handle big power. Has only done 1,500-1,600 easy going mile. Available as either the Short Block, SRD Race Head and Cams or can be bought together! Prices below are quite cheap as these are the last few bits i need to sell and they should be coming out the car at the end of this weekend. Certainly a fraction of what it wopuld cost to do yourself SRD Built short block: ARP Head Studs ARP Rod Bolts ARP Main Bolts ACL Rod Bearings ACL Main Bearings ACL Thrust Washers New Uprated Rings OEM rods and pistons Built by SRD. It was fully balanced, bore honed, line honed for the arp main studs, decked, cleaned and assembled - Bargain @ £2,000 SRD Stage 2 Race Head - Ported and Polished with BC uprated springs and titanium retainers - £1,000 SRD Race Cams - Stage 2: 269 profile, 9.6mm lift - £425 [ATTACH=CONFIG]150637[/ATTACH] [ATTACH=CONFIG]150638[/ATTACH] [ATTACH=CONFIG]150639[/ATTACH] Link to comment Share on other sites More sharing options...
Jamesy Posted April 27, 2012 Author Share Posted April 27, 2012 Had loads of pm's on this but no-one has confirmed yet. This little lot would cost a fortune to do from scratch plus you'd usually need an exchange block and exchange head. Should be ready for collection after monday Link to comment Share on other sites More sharing options...
Jamesy Posted May 1, 2012 Author Share Posted May 1, 2012 Engine and head sold Cams held for the time being, may be going with the engine Link to comment Share on other sites More sharing options...
Jamesy Posted May 1, 2012 Author Share Posted May 1, 2012 This is all sold to one lucky member Link to comment Share on other sites More sharing options...
Geo Posted May 1, 2012 Share Posted May 1, 2012 who? Link to comment Share on other sites More sharing options...
James Posted May 1, 2012 Share Posted May 1, 2012 Link to comment Share on other sites More sharing options...
Recommended Posts