FOSTA Posted April 20, 2012 Share Posted April 20, 2012 I've just cleaned out my master cylinder and I'm fitting new lines throughout and I'm not sure how much brake fluid I will need? Could somebody tell how much I will need to buy please This is what it looked like before: And now : Link to comment Share on other sites More sharing options...
tooquicktostop Posted April 20, 2012 Share Posted April 20, 2012 Someone likes white chocolate Link to comment Share on other sites More sharing options...
ScottC Posted April 20, 2012 Share Posted April 20, 2012 1.5 Litres http://www.mkivsupra.net/vbb/showthread.php?56684-FAQ-Oil-Fluid-Interval-Capacity-Steering-Brake-Coolant-Diff-Engine Link to comment Share on other sites More sharing options...
Westy Posted April 20, 2012 Share Posted April 20, 2012 How dirty is your engine bay!? Link to comment Share on other sites More sharing options...
FOSTA Posted April 20, 2012 Author Share Posted April 20, 2012 Someone likes white chocolate Hahahahah the family bought it all for easter for my 9month old twin girls lol Link to comment Share on other sites More sharing options...
FOSTA Posted April 20, 2012 Author Share Posted April 20, 2012 1.5 Litres http://www.mkivsupra.net/vbb/showthread.php?56684-FAQ-Oil-Fluid-Interval-Capacity-Steering-Brake-Coolant-Diff-Engine Cheers mate nice one! Link to comment Share on other sites More sharing options...
FOSTA Posted April 20, 2012 Author Share Posted April 20, 2012 How dirty is your engine bay!? Ha ha ha it wasn't from my engine bay mate lol Im deleting my abs system to clean up the engine bay so I bought this non abs mater cylinder off eBay so they must of never changed there fluid as this was stained really bad lol Link to comment Share on other sites More sharing options...
Robzki Posted April 20, 2012 Share Posted April 20, 2012 Just done mine and 1.5ltrs seems about right, buy 2ltrs to allow for top ups afterwards as the pads wear, also best to push all of the pistons back into the calipers and hold them all in with g clamps etc, that way you push a lot of the old fluid back up the system and out into the reservoir which you can then either syringe out or remove and empty. Then when you push the new stuff through you are only bleeding the lines almost straight out of the bleed nipple, with the pistons extended they all act as small reservoirs and the new mixes with the old and makes it difficult to get a complete flush. Hopefully this makes sense Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now