Noz Posted March 21, 2012 Share Posted March 21, 2012 Evening all, what impedance is required when using low resistance injectors, to increase them for high resistance. I can't remember the value on the resistors used in the resistor boxes. Thanks Quote Link to comment Share on other sites More sharing options...
Ian C Posted March 22, 2012 Share Posted March 22, 2012 I think it's 50? That might be for 10Base-T terminators though Heckler will know! Quote Link to comment Share on other sites More sharing options...
Nodalmighty Posted March 22, 2012 Share Posted March 22, 2012 Anything over 6 ohms is considered high impedance. So if your injectors are 2.5 ohms a 4R7 50w resistor should do the trick (per channel). Obviously if you are grouping the injectors ohms law applies. Lyndon. Quote Link to comment Share on other sites More sharing options...
heckler Posted March 22, 2012 Share Posted March 22, 2012 I use 6.8ohm 50w resistors... I can make a resistor pack up for you if required Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.