DaveD Posted December 6, 2011 Share Posted December 6, 2011 I recently picked up a OEM flywheel which supposedly has 12k miles from the United States. That's about 20,000 KMs. If you run your your finger along some parts its not exactly smooth (bit bumpy), not sure what you wanna call it.. hot spots or stress marks? If I just put it in like this it should be fine? If I have to get it machined that isn't a problem since its cheap.. but I have read somewhere that the OEM flywheel is not that easy to machine? http://img16.imageshack.us/img16/3716/img0383ab.jpg Quote Link to comment Share on other sites More sharing options...
DaveD Posted December 6, 2011 Author Share Posted December 6, 2011 anyone can chim in? Quote Link to comment Share on other sites More sharing options...
merckx Posted December 6, 2011 Share Posted December 6, 2011 anyone can chim in? The usual suspects who could give you some advice are probably working. Quote Link to comment Share on other sites More sharing options...
Chris Wilson Posted December 6, 2011 Share Posted December 6, 2011 You cannot re grind dual mass flywheels, if it passes the factory manual movement test routine it should be OK to re use, if not, weigh it in. As for the hot spots, doesn't look too bad, probably OK from that point of view. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.