Guest inthemix Posted September 22, 2011 Share Posted September 22, 2011 Hi everyone, I had the dealer install a Centerforce DF clutch and Fidanza flywheel about 10k miles ago. Recently, the clutch gets stuck to the floor on SOME occasions and I need to pull it back with my foot and everything is a go again until the thing does it again. This happens randomly. Shifts great otherwise, just an occasional stuck to the floor problem when getting it into gear or shifting. I was told it may be a master/slave cylinder issue, but it may also by a bad pressure plate in my opinion. Anyone else experienced this? If so, what was the problem? Thanks! Link to comment Share on other sites More sharing options...
caseys Posted September 22, 2011 Share Posted September 22, 2011 I'd recommend asking this in the Tech section chap. Link to comment Share on other sites More sharing options...
Missile Posted September 22, 2011 Share Posted September 22, 2011 Slave cylinder. I've had the exact same symtoms before changing for a new one. Not too expensive and a 10min job. Link to comment Share on other sites More sharing options...
Guest inthemix Posted September 23, 2011 Share Posted September 23, 2011 Thanks for the feedback bud! I have posted this same question in the tech dept. as well. I called my mechanic today (SP Engineering) and they said it may be a cylinder issue as well. Do they need to take the clutch/flywheel assembly apart to actually determine if it is simply a cylinder issue or can they confirm the problem by other means if it is in fact the cylinder? Thanks in advance... Link to comment Share on other sites More sharing options...
Missile Posted September 23, 2011 Share Posted September 23, 2011 I'd bite the bullet and get the slave done. Fingers crossed there won't be anything else needed. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now