justice Posted July 22, 2011 Share Posted July 22, 2011 I've just had my dash refurbished and I'm now in the process of putting it all back together. All I have left to do is the lighter, I know it sounds silly but I can't figure it out and I'm starting to break the little bits of plastic that hold it all in any help please?! Link to comment Share on other sites More sharing options...
justice Posted July 22, 2011 Author Share Posted July 22, 2011 It was a really silly question I know. I got too excited about putting my dash back together again I couldn't figure out something this easy. All done now though. Link to comment Share on other sites More sharing options...
marc_p Posted July 22, 2011 Share Posted July 22, 2011 Ok, numbering them by going clockwise from top left, put number 1 back into the dash, put number 2 into number 1(hook in from the front), push number 5 into number 2, then put number 3 over number 2, number 7 should clip into/onto the raised bit on number 2, number 6 goes into number 7(but should have wires attached to it) then, once all that is done, whack number 4 into place(from the front) Link to comment Share on other sites More sharing options...
marc_p Posted July 22, 2011 Share Posted July 22, 2011 Cr@p, should of taken the 5 seconds to read the second post:( Link to comment Share on other sites More sharing options...
justice Posted July 22, 2011 Author Share Posted July 22, 2011 Cr@p, should of taken the 5 seconds to read the second post:( thanks for the help though, its the thought that counts. Link to comment Share on other sites More sharing options...
Stephendjb Posted July 22, 2011 Share Posted July 22, 2011 It may help someone else out in the future.... Link to comment Share on other sites More sharing options...
justice Posted July 22, 2011 Author Share Posted July 22, 2011 It may help someone else out in the future.... never thought about it like that. I couldn't find an assembly thread just a "broken lighter" thread, that's why I posted. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now