hodge Posted February 16, 2011 Share Posted February 16, 2011 Hi guys For an RPM signal, do I use the tacometer wire it the igniter feedback wire on the ecu loom. Thanks John Quote Link to comment Share on other sites More sharing options...
Steve Posted February 16, 2011 Share Posted February 16, 2011 Is this for the Dash 2? If so it can come from the ECU on the CAN bus. Quote Link to comment Share on other sites More sharing options...
johnny g Posted February 16, 2011 Share Posted February 16, 2011 As Steve said, the CAN Bus connection between the Syvecs and the DASH2 will carry the whole datastream. If this is for your HUGE rpm dial, then I think you can pull it from the igniter. You'll need to configure that to 6 pulse per revolution too Quote Link to comment Share on other sites More sharing options...
hodge Posted February 16, 2011 Author Share Posted February 16, 2011 Guys I'm a total electronic retard. So are you saying I don't need to connect ANY wires for the speed, RPM or analog inputs for the dash2. The can BUS cable will do it all. OR can it be done either way, by using the can BUS or hardwiring it into the loom. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.