RobSheffield Posted January 19, 2011 Share Posted January 19, 2011 This is a TT6 Engine loom that has had VSV's removed, injector clips removed ready for pigtails to be soldered on, and RLTC removed. It will need a bit of work. If you know an auto electrician or you can solder wires you will be fine. You could i suppose make it into a TT loom with some effort. £90 plus post. Link to comment Share on other sites More sharing options...
RobSheffield Posted January 23, 2011 Author Share Posted January 23, 2011 Bump Link to comment Share on other sites More sharing options...
heckler Posted January 23, 2011 Share Posted January 23, 2011 Hey rob, are there any Broken connectors/wires etc? Been after one for ages. When you say the vsv plugs have been removed, have they just been cut off, removed completely, plugs and wires down to the ecu plug? Link to comment Share on other sites More sharing options...
RobSheffield Posted January 23, 2011 Author Share Posted January 23, 2011 I removed one of your resistor packs, so those yellow/green wires need soldering. I removed RLTC so the ECU area wires need soldering, I removed the injector clips and the VSV plugs (snipped wires and taped over) but the wires are still in the loom itself. Rob Link to comment Share on other sites More sharing options...
supra-spain Posted January 23, 2011 Share Posted January 23, 2011 j-spec? auto? Link to comment Share on other sites More sharing options...
supra-spain Posted January 23, 2011 Share Posted January 23, 2011 you have a photo? Link to comment Share on other sites More sharing options...
RobSheffield Posted January 23, 2011 Author Share Posted January 23, 2011 j-spec? auto? It was TT6, but its sold now. Link to comment Share on other sites More sharing options...
Recommended Posts