add heywood Posted January 17, 2011 Share Posted January 17, 2011 Just wanting to know peoples opinions on how many miles should be done before a mapping session. Had the headgasket changed and new cams fitted etc so block obviously was opened up. was thinking of around 1k... will set my rev limit to about 3k. What do you guys think? Quote Link to comment Share on other sites More sharing options...
johnny g Posted January 17, 2011 Share Posted January 17, 2011 I'd just put some running in oil in it, start up, check all is ok, run till teh block is warm, swap the oil for some semi synth and go for a 10-15 minute drive. Quote Link to comment Share on other sites More sharing options...
Geo Posted January 17, 2011 Share Posted January 17, 2011 I'd just put some running in oil in it, start up, check all is ok, run till teh block is warm, swap the oil for some semi synth and go for a 10-15 minute drive. what about cold map mapping setup, if the car was warm then cold mapping would be out would it not? Quote Link to comment Share on other sites More sharing options...
johnny g Posted January 17, 2011 Share Posted January 17, 2011 what about cold map mapping setup, if the car was warm then cold mapping would be out would it not? Probably be lumpy, but driveable. Personally, I'd get the mapper up, and do it when he's around. Have it all boxed off in half a day. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.