innovate LC1 wirring help

[barneybrendan]

i need to get my wideband connected its an innovate lc1.I have the sensor conected and the lc1 unit,but dont know what wire goes where now.need to know where all wires and connectors go in all 3 pics.

[Tricky-Ricky]

Here you go mate.

http://www.innovatemotorsports.com/support/manual/LC-1_Manual.pdf

 

You can download the full manual form here,

http://www.innovatemotorsports.com/support.php

[barneybrendan]

cheers i couldnt find that for trying.was getting confused as i dont have the push button or led,do i need this.plus the serial cables obviously dont get used then.

[Tricky-Ricky]

Looks like you also have the XD-16 gauge? if so it need to be hooked up by using the MTS serial cables to the LC-1 the rest of the wires will be power and earth stc,

if its an analog gauge it will use either the analog 1 or 2 outputs.

[barneybrendan]

pics of the gauge.does this mean the serial cables need to be connected to the gauge now then,take it i need 2 double ended male connectors.ref push button,do i need to get one as it says its to do with calibration.

[Tricky-Ricky]

Yes the serial cables connect them together, there should be enough cable to connect them without adding some, got a feeling its only one that needs to connect as the other is open for any other devices in the log chain, but i would have to re read the manual, as for the calibration cable, i will have a look at that too.

[Ian C]

I was looking up the innovate site while talking about this in PMs and then found tricky had done the legwork

 

The random picture of wires on your leg is:

 

a. Red 12V supply

b. Blue Heater Ground

c. White System Ground

d. Yellow Analog out 1 (you won't use this)

e. Brown Analog out 2 (plumb this into Option 2 on the EMU, as discussed I can't recall which pin)

f. Green Analog Ground

g. Black Calibration wire

 

Blue on the gauge is +12v, black on the gauge is ground.

[barneybrendan]

cheers guys found this little write up aout using the computer cable and explains the pin out from the emu

http://www.miataturbo.net/showthread.php?t=12754

 

thhen this one whichh helps connect thhe emu to the lc1

http://www.imazda.com/forums/showthread.php?t=303

[barneybrendan]

where can i get the double male connectors from to join the serial cables.