Mas Posted June 19, 2010 Share Posted June 19, 2010 Got rid of the rear toyota badge as I'll be doing a spray job on the boot after wiper removal, meanwhile is there anything i can cover the 3 small holes with, to stop water going inside and that doesnt look too stupid too? Quote Link to comment Share on other sites More sharing options...
Rob_Mitchell Posted June 19, 2010 Share Posted June 19, 2010 yeah weld them up and repaint the boot, simples Quote Link to comment Share on other sites More sharing options...
3LL Posted June 19, 2010 Share Posted June 19, 2010 you would have been best off leaving it tbh dude til you was ready to get the lot done.. all i can think is a trip to bnq see if theres any rubber gromits you can pop into the holes.. mind there gonna have to be small gromits. Quote Link to comment Share on other sites More sharing options...
nevins Posted June 19, 2010 Share Posted June 19, 2010 temporary fix, that will stop water black sealent, from the inside. Or you could just stick the badge back on. Quote Link to comment Share on other sites More sharing options...
hiten55 Posted June 19, 2010 Share Posted June 19, 2010 you could stay out of the rain. or use an umbrella? Quote Link to comment Share on other sites More sharing options...
evinX Posted June 20, 2010 Share Posted June 20, 2010 just put some bits of clear tape over the holes...if it leaves any residue on after you take it of, get a cloth and some wd40...or wet sand it then buff and polish:) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.