Tearing apart stock seats

[krisso_pl]

Im going to fit new seat covers for my supe and I started to wonder how to torn apart those seats? How to deinstall all those plastics and covers? Is there any manual how to change covers or how to tear the seats apart?

[nevins]

Pretty simple fella, take them out than just look at them for a bit and its self explanatory. Look at the rear of the seat and you will see two zips, the lever for the seat tilt is two allan key bolts and then this comes off. Pop the plastic switch knobs off these are easy to do. Then you have philips screws holding on the side trim.

 

Now remove the plastics off the opposite side, once thats done unzip the rear cover iirc the bottom is clipped over a bar. You can now start removing covers. For the base cover its also clipped on iirc. Off the top of my head the head rests are removed by releasing the clips inside the back of the seat.

Hope this helps you.

[Dave]

to remove headrest push down hard on the top corner of seat,just in front of that black thing on top of seat, other hand under headrest and pull, comes off easy

[Suprab1]

The headrest has 2 clips 1 at each side. Unzip the back & get your hands under the foam right up under the black thing that pops out on 1 side (same place on other side). It only has 1 groove in the bar at each side so when it moves a little it will just pull straight out.