Bill Prawn Posted April 24, 2005 Share Posted April 24, 2005 I have a water leak at the back of the wheel behind the belt. There is a bolt where it it seems to be dripping from. Water pump? Or something else? I have the technical knowledge of a Gnat so please treat me gently. Yes it did overheat, yes there was a small puddle under the car and no it's not still leaking. Any advice will be greatly appreciated. Link to comment Share on other sites More sharing options...
absz Posted April 24, 2005 Share Posted April 24, 2005 i take it you mean behind belt and fan not flywheel if so most prob its water pump Link to comment Share on other sites More sharing options...
Jake Posted April 24, 2005 Share Posted April 24, 2005 Sounds like water pump from your (crap ) description. Any chance of a pic of the bolt it's leaking from? The flywheel is behind the engine inside the gearbox bell housing. Link to comment Share on other sites More sharing options...
Bill Prawn Posted April 24, 2005 Author Share Posted April 24, 2005 Sounds like water pump from your (crap ) description. I said be gentle Any chance of a pic of the bolt it's leaking from? The flywheel is behind the engine inside the gearbox bell housing. Piccie here (it's crap as well) It's the bolt in the middle of pic. Link to comment Share on other sites More sharing options...
Chris Wilson Posted April 24, 2005 Share Posted April 24, 2005 Water pump seal and / or bearings are gone. there is a drain hole under the pump to allow water that seeps past the seal to escape, it's from this i would say the water is exiting from. I have pumps in stock. Get it done ASAP as it will get worse. maybe fail altogether. Not worth risking overheating or a blown head gasket or worse!! Top the water in the rad and overflow bottle up EVERY time you use the car, meanwhile. Link to comment Share on other sites More sharing options...
MONKEYmark Posted April 25, 2005 Share Posted April 25, 2005 same thing happend to mine, new water pump Link to comment Share on other sites More sharing options...
dude Posted April 25, 2005 Share Posted April 25, 2005 Unfortunatly you will have to take off the belt to do it (timing) , there is also a rubber o ring that goes between the pump rear assembly and the block but ive never seen one leak !!!! Dude Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now