Hoppy Posted June 13, 2009 Share Posted June 13, 2009 I'm about to fit my Blitz Power Meter but am unsure of which wire to connect the ORANGE speed signal wire to. Do i connect it to the RED/BLACK wire from the speed sensor / to the speedo or odo, or the PINK wire from the speedo or odo?? or even the PINK wire from ECU (pin A2) Any help would be much appreciated guys.Thanks Quote Link to comment Share on other sites More sharing options...
MarkR Posted June 13, 2009 Share Posted June 13, 2009 I think I connected mine to the wire coming from the ECU Quote Link to comment Share on other sites More sharing options...
Hoppy Posted June 13, 2009 Author Share Posted June 13, 2009 Was that the pink wire?? the same one as the Greddy BCC uses.cheers Quote Link to comment Share on other sites More sharing options...
MarkR Posted June 13, 2009 Share Posted June 13, 2009 I have a VVTI Tiptronic so the ECU and wires are different. Pretty sure it was pink though. It was a long time ago, but the pink wire is ringing a few bells. Quote Link to comment Share on other sites More sharing options...
Hoppy Posted June 13, 2009 Author Share Posted June 13, 2009 Ok mate thanks for that, i'll give it a go Quote Link to comment Share on other sites More sharing options...
MarkR Posted June 13, 2009 Share Posted June 13, 2009 Just remember that mine was a different ECU etc, so don't take my word for it. Quote Link to comment Share on other sites More sharing options...
JustGav Posted June 13, 2009 Share Posted June 13, 2009 Just had a quick read of the installation manual and it suggests that it should be fitted before any speed converters. I'd then look for your speed converter and connect it to the input end of that. IMPORTANT - When installing, ensure that the orange wire is connected to the ECU speed output before the speed de-limiter or speed converter (if fitted). If it is connected after this, it may cause incorrect operation of the unit. Quote Link to comment Share on other sites More sharing options...
MarkR Posted June 13, 2009 Share Posted June 13, 2009 Just had a quick read of the installation manual and it suggests that it should be fitted before any speed converters. I'd then look for your speed converter and connect it to the input end of that. Good call. I think I actually did that come to think of it. Quote Link to comment Share on other sites More sharing options...
Hoppy Posted June 13, 2009 Author Share Posted June 13, 2009 Right it's all wired up and so far so good. I now need some setup info please chaps : 1. Vehicle Weight ?? (i thought this was shown on my V5 but it's not) 2. Power Loss Setting (would i be correct to set this on -5 ??) Cheers Quote Link to comment Share on other sites More sharing options...
JustGav Posted June 13, 2009 Share Posted June 13, 2009 Right it's all wired up and so far so good. I now need some setup info please chaps : 1. Vehicle Weight ?? (i thought this was shown on my V5 but it's not) 2. Power Loss Setting (would i be correct to set this on -5 ??) Cheers Power loss setting is -5, yes... the weight I seem to remember is around 1700kg (But I'm really not sure on this) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.