Marco79 Posted May 11, 2009 Share Posted May 11, 2009 Hi just a quick question I'm wiring up some gauges into a pod that replaces the top glovebox, anyone know the best route to get wires through the bulkhead to the sender units, I couldn't see anywhere obvious :-/ Quote Link to comment Share on other sites More sharing options...
Wez Posted May 11, 2009 Share Posted May 11, 2009 Can either go out through the wing or where the main loom goes through on the passenger side. Quote Link to comment Share on other sites More sharing options...
Matt Harwood Posted May 11, 2009 Share Posted May 11, 2009 As Wez said. The easiest, and best way is to drop out a few bolts on the inner wing arch liner and look towards the bulhead. You should be able to see a nice big yellow gromit. Cut the end off and you can run as many cables as you like through it... Well, almost Quote Link to comment Share on other sites More sharing options...
Marco79 Posted May 11, 2009 Author Share Posted May 11, 2009 Cool thanks, to go through the wing is that drilling a strategic hole or is there an existing hole that can be used? Quote Link to comment Share on other sites More sharing options...
Marco79 Posted May 11, 2009 Author Share Posted May 11, 2009 Whoops the page hadn't refreshed when I put that last post up, cheers matt will look for the elusive yellow grommit :-) Quote Link to comment Share on other sites More sharing options...
Matt Harwood Posted May 11, 2009 Share Posted May 11, 2009 You can go either side, there are grommits on both sides, and they are large enough to fit a small exhaust pipe through!!! Quote Link to comment Share on other sites More sharing options...
Marco79 Posted May 11, 2009 Author Share Posted May 11, 2009 Thanks matt I just hate drilling holes when it's not needed a grommet will make life much easier lol Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.