damientt Posted March 13, 2008 Share Posted March 13, 2008 I bought a set of HIDs a few weeks ago and I've finally got round to thinking about fitting them .... but I can't see anywhere obvious to mount the ballasts. Any suggestions? Link to comment Share on other sites More sharing options...
TrickTT Posted March 14, 2008 Share Posted March 14, 2008 I have 2 mounted on the sides of the chassis rails under the headlights and another 2 mounted on the front crossmember. Link to comment Share on other sites More sharing options...
SupraJames Posted March 14, 2008 Share Posted March 14, 2008 I have one mounted buy my induction kit as there was a handy bolt hole there, and the other tucked between my battery and headlight. Link to comment Share on other sites More sharing options...
Scott Posted March 14, 2008 Share Posted March 14, 2008 I took both my headlights out and mounted them under where the lights sit. Scott =op Link to comment Share on other sites More sharing options...
AndrewOW Posted March 14, 2008 Share Posted March 14, 2008 I took both my headlights out and mounted them under where the lights sit. Scott =op If they fitted nicely, that's where I'd like mine to go, unless they may get hot there? Link to comment Share on other sites More sharing options...
Scott Posted March 14, 2008 Share Posted March 14, 2008 I can't see it to be honest, they are made to operate at their operating temperature (goes without saying) and i can't see them getting much hotter in there with cold air constantly blowing on them. Scott =op Link to comment Share on other sites More sharing options...
JODY T Posted March 14, 2008 Share Posted March 14, 2008 On the chassis rails is a good place.. Keeps the engine bay tidy.. Link to comment Share on other sites More sharing options...
bodilx6 Posted March 14, 2008 Share Posted March 14, 2008 As mentioned there's a mouting hole on the drivers side, just behind the airbox, left of the induction piping. On the passenger side, you can remove the bolt holding the washer fluid funnel and use the hole and bolt to fit the ballast. You should be able to fit the funnel nicely afterwards. All this of cause depends on what kind of mounting brackets you have available. Link to comment Share on other sites More sharing options...
AndrewOW Posted March 14, 2008 Share Posted March 14, 2008 Well the brackets that came with mine do seem to be quite large IMO. Around 5" x 3" (in old money). I'm assuming most mounting brackets are around this size too? Link to comment Share on other sites More sharing options...
Scott Posted March 14, 2008 Share Posted March 14, 2008 Well the brackets that came with mine do seem to be quite large IMO. Around 5" x 3" (in old money). I'm assuming most mounting brackets are around this size too? Yip, IIRC they are around that size. They fold over one another and use one mounting point to hold them? If i could get out of the house i would take pics for you. I'm sitting getting drunk instead! Scott =op Link to comment Share on other sites More sharing options...
razza Posted March 14, 2008 Share Posted March 14, 2008 I have one mounted buy my induction kit as there was a handy bolt hole there, and the other tucked between my battery and headlight. same as Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now