Hole in bulk head

[Dann]

In the engine bay, were abouts on a N/A supra does the wire loom go through in to the dash I cannot seam to see it.

 

On the gto it was at top drivers side same on my soarer but not on the supra.

 

I have some gauges I want to install and dont really want to drill new holes in the bulk head was hoping to run the wires through the existing hole is.

 

many thanks

 

dann

[Chris Wilson]

Through the big rubber bellow below the charcoal canister, passenger side top corner on a RHD car.

[Dann]

Thank you very much runs out to have a look.

[carl0s]

I could've sworn I did mine somewhere near the pedals. I think it was a rubber bung with nothing going through it until I made a hole in it. Was that a bad idea? Might have been nicer to use the existing loom's bung I suppose.

[Ric]

I could've sworn I did mine somewhere near the pedals. I think it was a rubber bung with nothing going through it until I made a hole in it. Was that a bad idea? Might have been nicer to use the existing loom's bung I suppose.

 

yes there is one there, but only on autos, the cylinder for the clutch goes through that hole on manuals

[JustGav]

The engine's loom runs through the grommit up on the bulkhead on the passenger side, there are some other little bits of loom that run through a grommit on the drivers side as well.