KingCole

Hi Swampy, I will get an EBC later down the line but just wanted to use MBC for the time being. Do you have any idea on the plumbing? Cheers Cole

Hi there, I am new to the 2jz platform and I have recently purchased a JDM TT Supra 6 speed. I am looking to install a manual boost controller (as seen by pictures) on the stock twin-turbo setup. After doing some research, I am confused as there are a few ways going about this and need to understand the best and easiest way. I am only looking to up the boost to around 15-16 psi. Does anyone have any idea on plumbing to install MBC on the stock twin turbos? Also which of the lines do I need to tap into? I have also attached the style of boost controller I will be using. I would really appreciate it if someone has actual pictures of this installed which also highlights the lines I need to tap. Cheers Cole

Thank you!!!!

You are 100% correct about the colours of the wires and where they go as I have the actual wire. I am trying to understand/read the diagram better, where on the diagram does it say Blue/White? It just says "LW" so how did you figure out that "L" actually refers to Blue wire?

Thank you sir! I was just on that pdf searching! you saved me a lot of time.

Hi guys, I need your help again, does anyone have the pinout for this plug? As I mentioned, the original plug was destroyed and I am not sure which wires go where. Thanks in advance. Cheers Cole

Hi guys, I am new to the Supra platform and today I started investigating my central locking issue on my RHD JDM Supra mk4. The car is fitted with an aftermarket Viper alarm system which also has central locking (not sure if Supra came factory with central locking) controlled via the remote. The issue was that only the passenger side operated correctly, the driver side locking was not working via the remote. I pulled the door cards off on both doors and noticed that there is no harness connected to the keyhole on the drivers side but there is on the passenger side. If I unplug this harness on the passenger side then the central locking stops working on this side too so I am convinced that having the same harness on the driver side harness would solve the issue. Does anyone know where I can get this harness? It is a 3 wire plug. Cheers Cole

Thank you!! - For anyone else looking for the part number for H6 plug, it is 90980–11292. Cheers

What a legend mate!!!!! Thank you!!!!!! Also thanks to scooter! Rider - Can you please advise how to get a part number for the plug? or is H6 connector unique across all toyota models?

Thanks for your response. Unfortunately, the original plug was crushed so I don't have it but I do have pictures of plug on the passenger side which goes in the same location but on passenger side. I am not sure if they are the same but here are some pictures. it is a 4-pin plug probably used for the lock actuator.

Hi guys, I need urgent help trying to figure out where to buy the plug or have a part number as seen in the diagram. Also does anyone have the wiring diagram for this too? This is used in a RHD Mk4 Supra door harness with Part No 82151-14591. Thanks

------