1_Tidy_1
-
Posts
35 -
Joined
Everything posted by 1_Tidy_1
-
Mm if its a 6 speed you will have to remove the pressure plate and the clutch plate, cause there isnt enough room in the transmission tunnel to remove the gearbox
-
Gearboxes in general are expensive to be repaired, and as they say poor man pays twice cause you cheapend out on not replacibg parts that had excessive wear, you may now have to strip box again and install becoming more down time,, and if parts seem excessively priced. Then hunt them down cheaper same product and then hand hem over and save money that way Dont try save money on shit like that cause normally it comes back to fuck you around at a later date
-
Also get a steel shafted screwdriver and use it as a stethoscope and try to locate the noise bit more accurate,, when the gearbox went in what did the spigot bearing and trow out bearing look like
-
You knoe that the getrag boxes are always a bit noisy. Obviously. Not like in the vid. But just sayimg. The problem you might of had, might of not been an issue from the start,, The current noise is definitely a assembly problem and needs to be looked into
-
Habe you contacted the gearbox people that just rebuild it,, cause they should foot the bill for there fuck up
-
Might be your wheel hitting the inner guards?
-
Yea I didnt think it was the diff bushes cause fisual they looked alright. But I had new polys in stocl so I installed them and the thumping noise went away
-
Yea that was my first thought as well but ended up being the bushes in the diff
-
If its a thump noise. change the oem front diff bushes to a poly bush, it will stop the diff twisting and that solved my noise completely
-
You can buy them at Toyota for a couple buks with the plastic,, ill look up the part number for ya