banaman69

im also interested to replace the vicsoe fan with an electric fan,probably be a Kenlowe.

hi C$ sup please let me know how you over came the problem of the different size sealing ring of the jap and the uk bulb.i know you can modify the locating plug.but the problem is the different size rings,the jap appears to be smaller diameter than the uk bulb.

can anyone suggest where i can get a new dipped beam headlamp bulb for my jap spec.can you only get them from toyota maindealer.or i there a conversion i could do.

me too,so all done and dusted what colour wire?

i have just bought the air/fuel meter from dawes-device,after seeing the manual boost controller which im also going to fit.i just need to know what colour wire to the ecu is the O2 sensor.

im about to fit an air/fuel meter and want to know to which oxygen sensor to fit connect it to,am i right is saying there is a rear and a front sensor.also what colour wire to connect to at the ecu from the sensor?

do you know what the ecu fault code shows,also is the light only only come on on high boost or hard acceleration.i recently had a knock senser fault.

give this web page a try http://www.heraeus.com/hh/eng/holding_home.nsf/$frameset/fAutomobilindustrie.

i also had idling trouble with my car,but then spayed copiuos amounts of wd40 over both side of throttle and i must admit the idle seems fine now.

ill have to wait about a weekso probably be fitting next weekend.ill let you know. i did call back to change the order to 1 controller instead of 2.hoping that my car has the 1 wastegate line is this correct anyone?

so when i enquired about the dawes device boost controller i would only need one as there is only one wastegate is that correct,its just that the guy said i needed 2.

well i have a 3ltr tt has the car 1 or 2 wastegates im not sure,anyone please let me know.

have just read your thread and went ahead and purchased the boost controller but was told that i would need 2 is that correct?

actually i should of said the isc(idle speed control) valve.

i have a slight idling problem,sometimes it idles at 1k and then sometimes 650.i have checked all hoses ok,could it be the icv if it is is it possible to strip down to inspect? jap spec tt.