energy

there was a BC installed when i buy the car,.. but i think it does not work how it should,.. i doesnt matter what gains or boost i config on it,.. my car is always going the same,.. so i thought 1) its broken 2) or it is not installed properly,.... so i think perhaps of the hoses,...

is there a mistake with my hoses ?!

thank your for your answer

This "Tube" (hose) was not sticked in and hanged around ?! What does this tube effect ?!?!i sticked it back !!

nobody has an idea?!

Hks Evc 3

Hello 2 all in my BC i can only set that bar and the OFFSET ( i think its the GAIn mode by other BC,but i am not sure) from 50%-150%.... what does this means ?! a higher or a lower offset... what is better ?! thank you

Hello 2 all I have another question for that topic,.. in my BC (at the 2nd picture) i can set the OFFSET ( i think its the GAIn mode by other BC,but i am not sure) from 50%-150%.... what does this means ?! a higher or a lower offset... what is better ?! thank you

Hello drivers,.. i need help,.. today i installed my TRD 320 speedo,.. it was very easy but i have no a probel,.. my sppedo is still running in MPH but in germany i need KMH,.. at the bills of the previous owner i saw that a DSC+TSD (combined) is installed.... because i have a j-spec i need the TopSpeedDelimiter but i dont need the DigitalSpeedConverter i thnik because i need it in KmH anybody has an idea how to fix that,..thank you cheers

thank you all !!

@Keith C At that Dyno time all the mods were installed,...

i have a SLD fitted i also have driven 170mph,.. this happended today the first time !! perhaps the fcd isnt installed correctly i will check it tomorrow!!! another question to the BC,.. at the back i have a switsch SW or PO where it must be switched i have it on internal wastegate ,..

@Gaz6002 Do you know perhaps what the reason when i accularate to 120mph and my machine "brakes" like an enigne brake?!

there is one fitted on the ecu,.. it has 4 cables and on it is written TRL !! i dont know if it is corretly installed but there is one avaialbe,... i want to drive 1.2bar,.. but it doesnt goes and i dont know why,.. how much would i have HP with 1.2 when i have with 1.0 335 ?! PS: have i know 335 at the wheels or at the machine ?!

so i have 385 HP or did i understand wrong ?! My problem is also with the boost controller,.. it doesn't matter how much bar i config,.. my supra drives always the same.... i noticed when i accularate that the boost only go a lil bit over 1 bar and then sink down again to .8-0.9 and today at a testdrive i noticed that my machnine stopped me at 120 Mph,... is something wring with my car ?!? I would like to feel my machine at 1.2 bar to see if i see any difference in power !!??? PS: how othe users have over 400 HP with j-spec bpu,.. how can i get it,..thank you